Skoda Octavia II 2004 Workshop Manual page 52

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Turn the eccentric of the tensioning pulley with offset screw‐
driver - T10264- clockwise -arrow- in such a way until the
pointer -2- stands in the centre of the base plate in the gap.
Note
Ensure that the fixing nut does not turn.
– Hold the eccentric of the tensioning pulley in this position and
tighten the fixing nut to 20 Nm plus a further 45° (
Note
When tightening the fixing nut, the pointer -arrow- turns max. 5
mm to the right from the gap of the base plate. This position must
not be corrected, because the toothed belt settles when running-
in.
– Insert counterholder - T10172- with bolt - T10172/4- as shown
in the illustration and by pressing in the -direction of arrow-
hold the tension of the timing belt on the tension side.
– Tighten securing bolts -1- to 25 Nm.
– Remove locking pin - 3359- and crankshaft arrester - T10050-
or crankshaft arrester - T10100 - .
Checking valve timing
– Turn crankshaft 2 turns in the direction of running of the engine
until the crankshaft is positioned shortly before TDC for cylin‐
der 1.
– Interlock during this motion the hub in the direction of running
of the engine with locking pin - 3359- .
– Check whether:
♦ The crankshaft can be locked with crankshaft arrester -
T10050 - or crankshaft arrester - T10100- .
♦ The pointer of the tensioning pulley -2- must be in area -a- of
the base plate -1-.
If the crankshaft cannot be arrested:
46
Rep. gr.13 - Crankshaft group
1
/ 8 turn).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�