Repairing Rear Brake Ci 38 (Vehicles With Front-Wheel Drive) - Skoda Octavia II 2004 Workshop Manual

2.5

Repairing rear brake CI 38 (vehicles with front-wheel drive)

Note
Brake inspection ⇒ page 8
♦
After replacing the brake pads, depress brake pedal firmly several times when the vehicle is stationary to
♦
ensure the brake pads are properly seated in their normal operating position.
Use the brake filling and bleeding device , e.g. -VAS 5234- , to drain the brake fluid from the brake fluid
♦
reservoir.
Use brake pedal loader , e.g. -V.A.G 1869/2- before removing a brake caliper or separating a brake hose
♦
from the brake caliper
1 - ABS wheel speed sensor
❑ clean the inner surface
of the hole before insert‐
ing the sensor and
brush over with a hot
bolt paste -
G 052 112 A3- .
2 - Screw, 8 Nm
3 - Screw, 90 Nm + 90°
❑ replace after each re‐
moval
4 - Wheel bearing housing
5 - Protection plate
6 - Screw, 12 Nm
7 - Wheel hub with wheel bear‐
ing
8 - Screw, 180 Nm + 180°
❑ replace after each re‐
moval
9 - Dust cap
10 - Brake disc
❑ Assignment, dimen‐
sions and wear limit
⇒ page 1
❑ if worn replace axle-
wise
❑ unscrew the brake cali‐
per before removing
11 - Screw, 4 Nm
12 - Brake pads
❑ Assignment, dimen‐
sions and wear limit
❑ always replace axle-wise
❑ Removing and installing
❑ Observe the instructions for changing the pad
13 - Brake carrier with guide bolts and boots
❑ must be assembled with sufficient grease on the guide bolt, supplied as a spare part
❑ fit a repair set if there is any damage to the protective caps or guide bolts, use the enclosed grease
packing to lubricate the guide bolts
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 1
⇒ page 120
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
⇒ page 111
119