Repairing Rear Brake Cii 41 (Vehicles With Front And Four-Wheel Drive) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
2.2

Repairing rear brake CII 41 (vehicles with front and four-wheel drive)

Note
Observe the instructions for changing the pad
♦
Brake inspection ⇒ page 8
♦
After replacing the brake pads, depress brake pedal firmly several times when the vehicle is stationary to
♦
ensure the brake pads are properly seated in their normal operating position.
Use the brake filling and bleeding device , e.g. -VAS 5234- , to drain the brake fluid from the brake fluid
♦
reservoir.
Use brake pedal loader , e.g. -V.A.G 1869/2- before removing a brake caliper or separating a brake hose
♦
from the brake caliper
1 - ABS speed sensor (vehi‐
cles with front-wheel drive)
❑ clean the inner surface
of the hole before insert‐
ing the sensor and
brush over with a hot
bolt paste -
G 052 112 A3- .
2 - Screw, 8 Nm
3 - Screw, 90 Nm + 90°
❑ replace after each re‐
moval
4 - Wheel-bearing housing (ve‐
hicles with front-wheel drive)
5 - Protection plate
❑ up to 05/2007 for wheel
bearing housing in steel
casting with 3 holes
❑ as of 06/2007 for alumi‐
nium wheel bearing
housing with 4 holes
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
parts
6 - Wheel-bearing housing (ve‐
hicles with four-wheel drive)
❑ different versions
❑ up to 05/2007 steel cast‐
ing version
❑ as of 06/2007 alumini‐
um version
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
parts
7 - Tighten screw 70 Nm + 90° (vehicles with four-wheel drive)
❑ replace after each removal
112
⇒ page 111
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�