Removing And Installing The Pump For Four-Wheel Drive Clutch - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Install O-ring -2- onto the oil filter carrier -1-.
– Insert connecting spring -4- into the oil filter -3-.
– Screw in screw cap -arrow- with a new O-ring and tighten.
– Checking oil level in the four-wheel drive clutch
⇒ "6.4 Checking oil level in the four-wheel drive clutch",
page 106 .
Tightening torques
♦ Screw cap for oil filter
⇒ "6.9 Disassembling and assembling coupling", page 128
6.7 Removing and installing the pump for
four-wheel drive clutch
⇒ "6.7.1 Removing and installing generation II four-wheel drive
clutch pump, final drive 02D, 0AV, Octavia II", page 110
⇒ "6.7.2 Removing and installing generation IV four-wheel drive
clutch pump, final drive 0BR, Octavia II, Superb II, Yeti, up to
10/2013", page 112
⇒ "6.7.3 Removing and installing V generation four-wheel drive
clutch pump, rear final drive 0BR, Yeti from 11/2013", page 114
6.7.1 Removing and installing generation II
four-wheel drive clutch pump, final drive
02D, 0AV, Octavia II
Removing
– Switch off ignition.
– Drain oil from the four-wheel drive clutch
⇒ "6.5 Drain off and fill oil for four-wheel drive clutch",
page 107 .
– Screw in new oil drain plug -A- and tighten.
110
Rep. gr.39 - Final drive - rear differential
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.