Removing And Installing The Sender For Fuel Gauge Display G - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Insert lock ring and tighten using the wrench - T30101 (3087)- .
– Connect fuel line
⇒ "2 Separating push-on couplings", page 211
Vehicles with auxiliary heating
– Attach fuel line to the dosing pump of the auxiliary heating and
additional heating at the closing flange.
Continued for all vehicles
Installation is carried out in the reverse order. Pay attention to the
following:
– After installing the fuel delivery unit, refuel with at least 5 litres
of fuel.
WARNING
Risk of explosion to fuel tank!
After installing a new fuel tank or completely emptying the fuel
tank, you must replenish with a minimum of 5 litres of fuel right
away. The fuel pump must not be allowed to start when the fuel
tank is completely empty.
Tightening torques
♦ ⇒ "1.4 Summary of components - fuel delivery unit and sender
for fuel gauge display", page 200
1.6 Removing and installing the sender for
fuel gauge display - G-
Removing
Note
Observe safety instructions
♦
⇒ "2.1 Safety precautions when working on fuel supply sys‐
tem", page 2 .
♦ Observe rules for cleanliness
⇒ "3.1 Rules of cleanliness", page 7
– Remove fuel delivery unit
⇒ "1.5 Fuel delivery unit with sender for fuel gauge display",
page 201 .
– Disconnect electrical plug connection -1- on the closing flange,
thereby unlocking the plug lock.
– Unhook the electric cable from the holder -arrow- and expose
it.
204
Rep. gr.20 - Fuel supply system
.
.