Avaya S8100 Series Manual page 749

Task
CAUTION:
Be sure to do this step
before freezing translations.
Change the circuit pack
locations from the TN750
Announcement circuit
packs to the TN2501AP
VAL circuit pack.
CAUTION:
Be sure to do this step
before freezing translations.
On the IP Services screen
in the Service Type field,
remove Alarm1 and
Alarm2.
CAUTION:
Be sure to do this step
before freezing translations.
On the Trunk Group
screen, change the
Measured field from
measured to none.
Description
The TN750 Announcement circuit packs are not
supported in the S8700-Series Media Servers.
The announcements translations come over to the
S8700-Series Media Server. However, the circuit
pack locations need to be changed to the TN2501AP
Voice Announcement over LAN (VAL) circuit pack.
NOTE:
All announcement names must be unique on a
TN2501AP Voice Announcement over LAN (VAL)
circuit pack. The announcement names cannot
contain any spaces, blanks, or the following
characters:
period (.)
●
forward slash (/)
●
colon (:)
●
asterisk (*)
●
question mark (?)
●
backward slash (\)
●
angle brackets (<>)
●
Type change announcements to change any
names and port locations.
You first might need to change the System
Parameters Maintenance screen before you can
make any changes to the IP Services screen.
This action indicates that trunk group measurement
reports are not required. Remember to remeasure
trunk groups.
Type list trunk-group to get a list of trunk groups
that are "measured" and need to be changed.
Prerequisites
3 of 4
Issue 2.1 June 2006 749