Avaya S8100 Series Manual page 1095

Setting the VLAN parameters and diffserv parameters
To set the VLAN parameters and diffserv parameters on the IPSI, if required:
1. Type telnet 192.11.13.6 to access the IPSI.
2. Enter show qos to display the quality of service values.
3. If necessary, use the following commands to set the VLAN parameters and the diffserv
parameters to the recommended values:
Note:
Use Help to obtain syntax guidelines for these commands.
Note:
Enter set vlan priority 6
●
Enter set diffserv 46
●
Enter set vlan tag on
●
Enter set port negotiation 1 disable
●
Enter set port duplex 1 full
●
Enter set port speed 1 100
●
4. Enter show qos to check the administered values.
5. Enter quit to end the IPSI session.
!
Important:
Ensure that the port settings on the Ethernet switches are set to the same values
Important:
as the values that appear in the set port commands.
6. Use the following steps to reset the IPSI and exit the IPSI IP Admin Utility.
a. Type telnet 192.11.13.6 to access the IPSI.
b. Enter reset.
c. Enter y in response to the warning.
d. Disconnect the laptop from the IPSI.
e. Verify that the LED display on the IPSI faceplate contains the letters I P and a filled-in V
at the bottom.
Repeat steps a
Note:
Clear the ARP cache on the laptop before you connect to another IPSI. To clear
Note:
the cache, enter arp -d 192.11.13.6 at the Windows command prompt.
through e for each of the other new IPSIs.
Conversion Tasks
Issue 2.1 June 2006 1095