Avaya S8100 Series Manual page 1053

Conversion tasks checklist
The following checklist identifies the major tasks in the conversion procedure:
Changing direct-connect synchronization
●
Adding new circuit packs
●
Upgrading firmware on new circuit packs.
●
Disabling PNC duplication.
●
Removing fiber administration.
●
Enabling PNC duplication.
●
Removing fiber-related hardware.
●
Administering PN synchronization.
●
Completing post-conversion tasks
●
Changing direct-connect synchronization, if necessary
If you are not converting the PN that contains the direct-connect synchronization source, do not
perform this procedure. Continue to
Note:
The administration of synchronization for a direct-connect configuration is the
Note:
same as for a CSS synchronization. For a direct-connect configuration, the
synchronization commands and screens use "CSS."
!
Important:
Synchronization for a direct connect configuration is derived from a fiber-PNC
Important:
PN. If you are converting only one PN to IP-connect, Avaya recommends that
you do not convert the PN that contains the synchronization source. If you are
converting the PN that contains the synchronization source, convert this PN last.
Adding new circuit packs
Conversion Tasks
on page 1055.
Issue 2.1 June 2006 1053