Avaya S8100 Series Manual page 1155

Task
19. Remove endpoints that
will be controlled by
the new ICC from the
current primary
controller.
20. Verify that the media
gateway has
registered with the
ICC.
21. Reboot LSPs (if any)
22. Verify LSP translations
date and time (if any).
23. Verify LSP status (if
any)
24. If the LSPs (if any)
translations have not
synchronized with the
ICC, invoke translation
synchronization.
On the LSP's primary controller
Remove users/endpoints from the current
●
primary controller.
On the new ICC
Open a SAT session and enter list
●
media-gateway. Verify that the
Registered field (Reg?) is set to y.
Place a test call.
●
On LSPs of the new ICC (if any)
At the LSP's SAT prompt, enter reset system
4.
To view the LSP's translations date and time,
enter list configuration software.
On the ICC
At the SAT prompt, enter list
●
survivable-processor(for CM R3.1)
or list lsp (for CM R2.x). The LSP
name and IP address should be listed.
The Translations Updated date and time
●
should match the translations date and
time on the primary controller. To view the
primary controller's translations dates and
times, enter list configuration
software-version.
On the ICC, enter the Linux command
●
filesync -a trans.
Ensure that the translation synchronization
●
completed successfully. Wait several
minutes, then check the timestamp of the
LSP's translation files using the SAT
command list
survivable-processor or list lsp
on the ICC.
Steps/Comments
Issue 2.1 June 2006
Introduction
1155