Avaya S8100 Series Manual page 688

Migrating from a DEFINITY Server SI in an SCC to an S8700-Series Media Server with Fiber-PNC
Adding IPSI information
To add IPSI information:
1. Type add ipserver-interface PNnumber where PNnumber is the port network
number. Press Enter.
2. When you use a DHCP server, verify that the fields that are associated with the primary IPSI
and secondary IPSI (if equipped) are populated with default data. The DHCP server sets
the Host and the DHCP ID fields.
3. Verify the correct setting for the IP Control field:
If IPSIs are in IP-connected PNs, set the IP Control field to y.
●
If IPSIs are in fiber-connected PNs (CSS or ATM), set the IP Control field to y.
●
If IPSIs are in fiber-connected PNs (direct-connect), set the IP Control field to y unless
●
more than one IPSI is present. If more than one IPSI is present, set the IP Control field
for the second IPSI to n.
If an IPSI is in a DS1-C–remoted PN, set the IP Control field to n to maintain the 5:1 ratio
●
of IPSIs to PNs. If the field is set to y, the system decreases the ratio to 2:1.
4. Verify that all the other fields are populated.
5. Press Enter to put the changes into effect.
6. Repeat Steps 1 through 5 for each port network.
Setting the alarm activation level
To set the alarm activation level:
1. Type change system-parameters maintenance. Press Enter.
2. In the CPE Alarm Activation Level field, select warning, minor, or major, depending on
the level that the customer wants. The default is none.
688 Upgrading, Migrating, and Converting Media Servers and Gateways