Avaya S8100 Series Manual page 1066

Converting some or all direct-connect port networks to IP-connect
Disabling PNC duplication, if necessary
If the bearer network is duplicated, you must remove the duplication before you remove the
fiber-optic connections. If the system does not have PNC duplication, continue with
fiber-related administration
To remove PNC duplication, log in to the SAT and complete these steps:
1. Enter status pnc to check which of the duplicated PNCs is active.
2. If the B-PNC is active, enter reset pnc interchange to make the A-PNC active.
3. Enter busyout pnc-standby to busyout the standby PNC.
4. Enter change system-parameters duplication to open the duplication screen.
5. In the Enable Operation of PNC Duplication? field, enter n and press Submit.
Removing fiber-related administration
Before you can use the IP connections, you must remove the fiber administration for each PN
that you are converting to IP-PNC.
Complete the following steps at the SAT to busyout and remove the fiber links for each PN that
you are converting to IP-PNC:
Tip:
To view the fiber link numbers and the endpoints, enter list fiber-link.
Tip:
1. Enter busyout fiber-link n, where n is the link number for the fiber connection.
2. Enter remove fiber-link n.
3. Repeat steps
Enabling PNC duplication, if necessary
If the final configuration is a mixture of fiber-PNC and IP-PNC PNs and if the fiber- connect
portion is duplicated, you must enable PNC duplication.
To enable PNC duplication at the SAT:
1. Enter change system duplication to open the PNC Duplication screen.
2. Enter y in the Enable Operation of PNC Duplication? field and press Submit.
1066 Upgrading, Migrating, and Converting Media Servers and Gateways
on page 1066.
1 and 2 for each IP-PNC PN.
Removing