Avaya S8100 Series Manual page 1171

Configuring the S8500 LSP
To configure the new S8500 LSP, perform the following steps:
Note:
Do not install the license and authentication files until after you have administered
Note:
the primary controller. For more information, see
controller
Note:
If the S8500 Media Server has a NIC card, it can be removed. As an LSP, the
Note:
S8500 Media Server does not use it.
1. On the Maintenance Web Page, click Server Date and Time
a. Choose - Set Date and Time Zone: The time of the LSP must be set to the same time
zone as its primary controller. The time must be set even if the LSP is physically located
in a different time zone.
2. Run the Configure Server command. Select the Configure Individual Services method.
a. Choose - Set Identities:
Enter the host name for the LSP.
●
Check the Server ID (SVID) value in the ID field. The primary controller is set to
●
SVID 1. If the primary controller is a duplicated S8700-series Media Server, the server
IDs are SVID 1 and SVID2. The ID for an LSP must be greater than 2 and less than or
equal to 256. Gaps in the numbering are allowed. For example, SVIDs can be 10, 20,
30, . . .. However, the SVID must be incrementally higher than the highest ID of other
existing LSPs or ESSes.
Select the default Ethernet 0 in the Control Network A field.
●
Select the default Ethernet 1 in the Services Port field.
●
Select the default Ethernet 0 in the Corporate LAN field.
●
Select the default unused in the Control Network B field.
●
Select the Corporate LAN in the Assign a Processor Ethernet interface
●
b. Click Continue.
c. Enter the following IP Addresses on the Configure Interfaces Web page.
The IP address for the LSP in the IP address servr1 field.
●
The IP address for the LAN gateway in the Gateway field.
●
The subnet mask for the LSP in the Subnet mask field.
●
AUTO SENSE in the Speed field.
●
d. Click Change.
on page 1174.
Administering the new primary
Issue 2.1 June 2006
Checklist
1171