Figure 19: Connecting directly to the IPSI
cadlipsi KLC 031502
Figure notes:
1. Services laptop
2. PCMCIA Network Interface Card (NIC)
Note:
Ensure that you have the IPSI password before you continue.
Note:
Clearing the ARP cache on the laptop computer
You might need to clear the Address Resolution Protocol (ARP) cache before you enter a new
IP address. This need depends on the operating system on your laptop computer. If you enter
an IP address and your computer cannot connect, you might need to clear the cache.
To clear the ARP cache on the laptop:
1. Click Start > Run to open the Run dialog box.
2. To open an MS-DOS command line window, type command. Press Enter.
3. Type arp -d 192.11.13.6. Press Enter. This command produces one of the following
responses:
The command line prompt displays when the cache is cleared.
●
The message The specified entry was not found appears when the specified IP
●
address does not currently appear in the ARP cache.
1
2
Post-migration administration
3
4
3. NIC adapter cable (if necessary)
4. CAT5 cross-over cable to IPSI
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
Issue 2.1 June 2006
505