Avaya S8100 Series Manual page 692

Migrating from a DEFINITY Server SI in an SCC to an S8700-Series Media Server with Fiber-PNC
3. Perform one of the following actions:
If you want to reuse the EI circuit pack in a G650 Media Gateway:
●
a. Move the EI/ATM Interface circuit pack from location C02 to location A01.
b. If this system is a critical-reliability system, move EI/ATM Interface circuit pack from
location D02 to location B02.
If you do not want to reuse the EI circuit pack in a CSS, continue with Step 4.
●
4. If you are using ATM EIs:
a. Use a cable pass-through kit to run the fiber optic cables for the expansion interface
circuit packs through the media gateway.
b. Connect the fiber optic cables to the connector on the front of the expansion interface
circuit packs. The LED lights when the cables are connected correctly.
Turning on the media gateway
To turn on the media gateway:
1. Turn on the media gateways.
2. Remove the emergency ground wire if used.
Post-migration administration
Accessing the server command line interface with SSH protocol
Note:
Using the SSH protocol to access the server is applicable to CM Release 3.0 and
Note:
forward.
To use this procedure with a laptop cable connection to the services port, you must configure
your laptop for the network connection. See
third-party SSH client must already be installed on your computer.
692 Upgrading, Migrating, and Converting Media Servers and Gateways
Network configuration on page 1242. In addition, a