Avaya S8100 Series Manual page 337

Verifying system status
Check which groups are in- or out-of-service before the migration. After the migration, compare
the after the migration list with the before the migration list to ensure that the lists are the same.
To verify system status:
1. To determine whether the system has administration, run the following commands:
a. list configuration all
b. list trunk-group
c. list hunt-group
If any command does not complete successfully, escalate the problem immediately. After
the migration, check the same administration to ensure that the translations are intact.
Recording all busyouts
To record busyouts:
1. Type display errors. Press Enter.
2. Look for type 18 errors and record any trunks that are busied out. You can return these
trunks to the busyout state after the migration/upgrade.
Recording node names and IP addresses
To record node names and IP addresses:
1. Note the node names and the IP addresses that are assigned to the TN2302AP IP Media
Processor and the TN799C/DP C-LAN circuit packs. Ensure that these names and
addresses are the same after the migration.
Note:
If the existing system has TN799C C-LAN circuit packs, you must replace these
Note:
circuit packs with TN799DP circuit packs.
2. To get the node names for the TN2302AP IP Media Processor and TN799C/DP C-LAN
circuit packs, type display ip-interfaces. Press Enter.
3. To get the IP addresses that match the node names, type list node-names. Press
Enter.
4. Record the information for use after the migration.
Premigration administration
Issue 2.1 June 2006 337