Avaya S8100 Series Manual page 1218

Converting simplex bearer to duplicated bearer on IP-PNC port networks (with S8700-series Media Servers
status media-processor board 1c03
Duplication State: active
Board Location: 1c03
Source IP Address: 192.168.22.11
Subnet Mask: 255.255.255.0
Gateway Address: 192.168.22.255
MAC Address: 00:00:04:0d:05:03
Ethernet Enabled? yes
Links
mpcl: up mj: 0
eth: up mn: 0
peer: up wn: 0
DSP 1: in-service/active, 60 calls
DSP 2: in-service/active, 50 calls
DSP 3: in-service/active, 57 calls
DSP 4: in-service/active, 47 calls
3. Look at the LINKS and DSP CHANNEL STATUS categories to determine whether the call is
being processed.
4. Type set media-processor UUCSS, where UUCSS is the location of the standby
TN2602AP circuit pack.
The standby TN2602AP circuit pack becomes active.
5. Type status media processor board UUCSS, where UUCSS is the location of the
newly-active circuit pack.
The Media Processor Status screen appears. Under DSP CHANNEL STATUS, the test call
has moved to the column for the newly-active TN2602AP circuit pack.
Note:
TN2602AP call processing and interchange activity is tracked through the
Note:
MEDPRO-C maintenance object. See Maintenance Alarms for Avaya
Communication Manager 3.1, Media Gateways and Servers, 03-300430, for
more information.
1218 Upgrading, Migrating, and Converting Media Servers and Gateways
Node Name: medpro1
COMMON DUPLICATED VALUES
Alarms Standby Refreshed: yes
Network Region: 1
Shared IP Address: 135.9.72.52
Shared Virt-MAC: 02:00:04:0d:05:18
MEDIA-PROCESSOR STATUS
Duplication State: standby
Board Locations: 1c07
Source IP Address: 192.168.22.51
Gateway Address: 192.168.22.255
Ethernet Enabled? yes
DSP CHANNEL STATUS
DSP 1: in-service/standby
DSP 2: in-service/standby
DSP 3: in-service/standby
DSP 4: in-service/standby
Page 1 of 1
Node Name: medpro2
Subnet Mask: 255.255.255.0
MAC Address: 00:00:04:0d:05:07
Locked? no Links
mpcl: up mj: 0
eth: up mn: 0
peer: up wn: 0
Alarms