Avaya S8100 Series Manual page 455

Migration tasks
The information in this section is based on the assumption that the media server complex is
installed, configured, and operational.
!
CAUTION:
This migration affects service. When the PPN is turned off, the system drops all
CAUTION:
calls. Service returns when the media server takes control of the IPSIs.
The following list describes the general migration procedures:
Turn off the processor gracefully - pre-conversion administration
●
Replace the processor circuit pack or tone clock circuit pack with an IP Server Interface
●
(IPSI) circuit pack
Connect the IPSI circuit pack to the Ethernet switch on the customer network
●
Assign an IP address to the IPSI circuit pack
●
You can reuse the translations from the existing system when you migrate to an S8500 Media
Server.
Note:
You must install the new Communication Manager license file on the media
Note:
server before you make the change or the system will not run.
Perform the following tasks to convert a processor port network to a port network (CMC).
Premigration administration:
Connecting to the processor
●
Verifying system status
●
Recording all busyouts
●
Recording node names and IP addresses
●
Saving translations
●
Migration tasks:
Accessing the media server maintenance web interface
●
Copying translation files to media server
●
Restoring translation files
●
Administering the IPSIs
●
Adding IPSI translations to Communication Manager
●
Setting the alarm activation level
●
Backing up translations
●
on page 457
on page 457
on page 458
on page 458
on page 459
on page 459
on page 460
on page 461
on page 461
on page 458
on page 459
on page 461
Migration tasks
Issue 2.1 June 2006 455