Avaya S8100 Series Manual page 911

1. Use a paperclip to open the CD-ROM drive on the media server.
2. Place the CD-ROM with Communication Manager in the CD-ROM drive.
3. Connect the AC power cord to media server 1 and to UPS 1 to turn on the media server.
!
CAUTION:
Do not push the UID button that is located above the power button. If you push
CAUTION:
the UID button, you reset the UID on the media server.
4. Push the power button.
Accessing the media server
To access the media server:
1. Clear the ARP cache from the laptop if necessary. For more information, see
ARP cache on the laptop computer
2. Connect the laptop to the Services port (2) on the back of the media server with a
cross-connect cable.
3. Wait at least 3 minutes after you turn on the media server. Then start an SSH session to
access the information on the CD-ROM.
Configuring Telnet for Windows 2000 or Windows XP
You can set the Microsoft Telnet application to send a carriage return (CR) and a line feed (LF)
whenever you press Enter. The installation program sees this as two key presses. If you are
running Windows 2000 or Windows XP, you must correct this before you copy the Remaster
Program to the hard disk.
1. Click Start > Run to open the Run dialog box.
2. Type telnet. Press Enter to open a Microsoft Telnet session.
3. Type display. Press Enter to see the current settings.
4. Perform one of the following actions:
If the system displays the message Sending only CR, close the dialog box.
If the system displays the message Sending both CR & LF, continue with step 5.
5. Type unset crlf. Press Enter.
6. Type display. Press Enter to verify that the settings changed. The system displays the
message Sending only CR.
7. Close the dialog box.
on page 902 and return here.
On the first S8710 Media Server
Clearing the
Issue 2.1 June 2006 911