Avaya S8100 Series Manual page 1149

Converting S8300 LSP mode to ICC mode
Introduction
This module provides a high-level list of tasks for converting an S8300B in LSP mode to primary
controller (ICC) without performing an upgrade. To complete these tasks, you will need
the following additional documents:
Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server,
●
555-234-100. To obtain this document, go to
Installations, Migrations, Upgrades & Configurations; then select the appropriate
document.
Administrator Guide for Avaya Communication Manager, 03-300509.
●
In this scenario, an S8300B, configured as an LSP, is converted to an S8300B standalone ICC
primary controller. In both modes, the S8300B is running Communication Manager release 2.1
or later and no software/firmware upgrade is performed.
The tasks include:
1. Removing the LSP from the current primary controller.
2. Updating the DHCP server alternate controller list.
3. Updating the gateway MGC list.
4. Installing IA770 messaging, if using it.
5. Setting date, time, and time zone.
6. Installing CM service pack, license, and authentication files, as needed.
7. Configuring the S8300B as an ICC.
8. Administering the new ICC and its media gateway.
9. Moving the endpoints supported by the current primary controller to the ICC.
Follow the detailed procedures in Installing and Upgrading the Avaya G700 Media Gateway and
Avaya S8300 Media Server, 555-234-100, Issue 9, February 2006, for most of the tasks in this
conversion scenario.
http://support.avaya.com
Issue 2.1 June 2006
Introduction
and navigate to
1149