Avaya S8100 Series Manual page 734

Migrating a DEFINITY Server SI in an MCC to an S8700-Series Media Server with Fiber-PNC
Assigning IP addresses to the IPSI circuit packs
The IP server interface circuit packs receives IP addresses when you use the dynamic host
configuration protocol (DHCP).
Using DHCP addressing
So that the TN2312BP IPSI circuit packs can receive IP addresses dynamically, you must
assign the switch ID and the cabinet number to each IPSI circuit pack. The switch ID is A
through J. The cabinet number is 01 through 64. For G650 Media Gateways, a cabinet is
defined as one or more media gateways connected by TDM cable. This cabinet configuration is
called a G650 rack mount stack.
Administering the location assignment
To administer the location assignment:
1. Fully insert the TN2312BP IPSI circuit pack. If necessary, reseat the circuit pack to start the
programming sequence.
Note:
You must start the following steps within 5 seconds after you insert the circuit
Note:
pack.
Note:
For the following step, do not use a graphite pencil.
Note:
734 Upgrading, Migrating, and Converting Media Servers and Gateways