Avaya S8100 Series Manual page 1208

Converting simplex bearer to duplicated bearer on IP-PNC port networks (with S8700-series Media Servers
Determining the existence and location of TN2302 and TN2602AP
circuit packs
To determine the location of existing TN2302 IP Media Processor circuit packs, perform the
following steps:
1. Type display circuit-packs <port network #>, where <port network #> is
the port network in which you are adding duplicated TN2602AP circuit packs.
A list of circuit packs appears.
2. Locate, and record the location of, the TN2602AP circuit packs, if any. If there is only one or
no TN2602AP circuit packs, locate one or two TN2302 circuit packs for replacement with
TN2602AP circuit packs.
Avaya recommends, when possible, that you install duplicated TN2602AP circuit packs in
different carriers or cabinets. Doing so adds reliability in the event of carrier or cabinet
failure.
3. Type display ip-interface UUCSS for each of the TN2302 circuit packs you are
replacing or the currently installed TN2602AP circuit packs, if any. Record the existing
administrative data. You can use the same node names and IP addresses as those formerly
used by the TN2302 circuit packs.
Upgrading firmware on the existing TN2602AP circuit packs, if
necessary
If you determined that you must upgrade the firmware on existing TN2602AP circuit packs, do
so now.
1. Type campon-busyout media-processor UUCSS, where UUCSS is the location of a
TN2602AP circuit pack you are converting, and press Enter.
2. Wait until all calls the circuit pack is carrying have ended.
3. Upgrade the firmware. (See Upgrading, Migrating, and Converting Media Servers and
Gateways (03-300412), "Chapter 4: Upgrading Firmware on TN Circuit Packs and Media
Modules.")
4. When the firmware has been installed, type release board UUCSS, and press Enter.
5. Repeat steps 1 through 4 for the other TN2602AP circuit pack, if it exists.
1208 Upgrading, Migrating, and Converting Media Servers and Gateways