Avaya S8100 Series Manual page 1159

At the customer site
Perform the tasks in this section at the customer site.
Task
Go to the standard documentation
Use Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media
Server, 555-234-100, Issue 9, February 2006.
To convert the ICC to an LSP, you complete selected tasks from Chapters 9 and 12. You need
to complete only some of the tasks in these chapters. The specific tasks are identified by
section in the left-hand column. The subtasks to perform are listed in the right-hand column.
It is important to note where the task is performed. Most of the tasks are done on a server or
gateway — on the ICC/LSP S8300, on the primary controller for the LSP, on a DHCP server, or
on the gateway processor (MGP). The headings in the table indicate on which of these devices
the task is performed.
1. Administer the primary
controller that the LSP
(after conversion) will use.
See "Administer
Communication Manager"
in Chapter 9.
2. Administer the media
gateway.
See "Administering the
Media Gateway" in
Chapter 9.
On the new LSP's primary controller
Assign node names
●
Administer network regions
●
Associate LSP with a network region
●
Administer IP interfaces
●
Identify LSPs to the primary controller
●
Administration of the S8400, S8500, or S8700-series
primary controllers are the same. Administration of an
S8300 primary controller is somewhat different.
Add media gateway
●
Repeat for each gateway controlled by the current
●
ICC.
For this scenario, the gateway will not automatically
register with the primary controller at this point. Skip the
subtasks Verify Changes and Save Translations in this
section.
When the gateway finally registers, the media modules
will automatically populate, unless you are doing
administration without hardware (AWOH). In this case,
you will have to enter the media module types for each
slot.
Steps/Comments
Issue 2.1 June 2006
Introduction
1 of 5
1159