Avaya S8100 Series Manual page 1060

Converting some or all direct-connect port networks to IP-connect
3. Connect the other end of the CAT5 cable to the Ethernet switch.
4. For the G650 gateway only, if the maintenance function is used, connect one end of the
serial maintenance cable to the DB9 connector on the IPSI adapter. Connect the other end
to the Emergency Transfer panel to provide 1 alarm output and 2 alarm inputs.
Connecting the media processor cables
!
Important:
If you are replacing a TN2302 with a TN2602, ensure that you replace the
Important:
TN2302 I/O adapter with a TN2602 adapter.
To connect a media processor slot to the LAN:
1. Connect the medial processor I/O adapter to the backplane amphenol connector that
corresponds to the slot in which the media processor circuit pack is installed.
2. Connect a CAT5 or better Ethernet cable to the top RJ45 jack on the media processor I/O
adapter. This jack is labeled Port 1.
3. Connect the other end of the CAT5 cable to an RJ45 jack on the customer LAN.
Connecting CLAN cables
You can install the CLAN circuit packs in any universal port slot.
To connect a CLAN slot to the LAN:
1. Connect the TN799DP I/O adapter to the backplane amphenol connector that corresponds
to the slot in which the TN799DP is installed.
2. Connect a CAT5 or better Ethernet cable to the RJ45 jack on the TN799DP I/O adapter.
3. Connect the other end of the CAT5 cable to an RJ45 jack on the customer LAN.
Administering the new circuit packs
!
Important:
In addition to the administration procedures described in this section, you might
Important:
also need to adjust the administration of the network regions. Your planning
documents might provide information about changes to network regions. For
more information on how to administer network regions, see Administration for
Network Connectivity, 555-233-504.
Tip:
To avoid the loss of new translations, save translations frequently during the
Tip:
administration process.
1060 Upgrading, Migrating, and Converting Media Servers and Gateways