Avaya S8100 Series Manual page 1154

Converting S8300 LSP mode to ICC mode
15. Administer the new
ICC.
See "Administering an
S8300 primary
controller" in Chapter
9.
16. Administer the media
gateway.
See "Administering the
Media Gateway" in
Chapter 9.
17. Reassign endpoints
from the current
primary controller to
the standalone ICC.
For information on
updating translations,
see the Administrator
Guide for Avaya
Communication
Manager, 03-300509.
18. Reboot the ICC.
1154 Upgrading, Migrating, and Converting Media Servers and Gateways
Task Steps/Comments
Assign node names.
●
Administer network regions.
●
Associate other LSPs (if any) with a
●
network region.
Add IP interfaces
●
Identifying LSPs to the primary controller
●
Add media gateway.
●
Repeat for each gateway to be controlled
●
by the new ICC.
For this scenario, the gateway will not
automatically register with the ICC at this point.
Skip the subtasks, Verify Changes and Save
Translations in this section.
When the gateway finally registers, the media
modules will automatically populate, unless you
are doing administration without hardware
(AWOH). In this case, you will have to enter the
media module types for each slot.
Update translations — add stations and
●
trunks
- Using the Avaya Installation Wizard and
the Electronic Pre-Installation Worksheet
(EPW) is recommended.
- Alternatively, use SAT commands.
Place test calls to verify.
●
Reassign messaging system users of the
●
current primary controller to the messaging
system used by the new ICC. Enter test
messages to verify.
Open a SAT session and enter reset system
4.
After the reboot, any LSPs should be registered
with the ICC, and in a few minutes translations
should be synchronized.