Avaya S8100 Series Manual page 1091

Installing the IPSI circuit packs
Add the IPSI TN2312BP circuit packs to the slots that you designated for the IPSIs.
To install an IPSI circuit pack:
1. Complete the following steps to replace the TN2182 tone clock circuit pack with an IPSI:
!
CAUTION:
The TN2312 IPSI must replace the TN2182 tone clock. Do not install the IPSI in
CAUTION:
addition to the tone-clock. Major system disruptions can occur if a PN contains
both circuit packs.
!
Important:
If the control network for this PN is duplicated, replace the standby tone clock
Important:
first.
a. If the PN has duplicated control networks, and you replaced the standby tone-clock with
an IPSI at location UUC, enter set tone-clock UUC,where UUC is the standby tone
clock location. This command interchanges the active and standby tone clocks.
b. Enter the SAT command
busyout tone-clock UUC, where UUC is the standby tone clock location.
c. Remove the standby TN2182 tone clock.
2. Insert the IPSI circuit pack into the slot that the tone clock previously occupied by.
3. Push firmly on the faceplate until the circuit pack is properly seated, then close the latch.
4. After about 1 minute, to open the SAT Circuit Packs screen, enter
display circuit-pack cabinetnumber. Verify that the TN2312B circuit packs are
shown in the appropriate slots.
5. If the IPSI replaced a tone clock, enter the SAT command enable tone-clock UUC,
where UUC is the IPSI circuit pack location.
For the S8700-series Media Servers only, you can include an additional IPSI in the PN for
control duplication.
Installing the media processor circuit packs
Add the media processor circuit packs to the slots that you designated for media processors.
To install a media processor circuit pack:
1. Insert the TN2602AP circuit pack into the slot that you previously prepared for the media
processor.
2. Push firmly on the faceplate until the circuit pack is properly seated, then close the latch.
3. After about 1 minute, to open the SAT Circuit Packs screen, enter
display circuit-pack cabinetnumber. Verify that the TN2312B circuit packs are
shown in the appropriate slots.
Conversion Tasks
Issue 2.1 June 2006 1091