Avaya S8100 Series Manual page 991

/opt/ecs/sbin/drestart 2 4 command failed.
Ignore this message. You must wait until the restart/reset completes before entering
additional commands.
The media server displays a message that the software update (patch) was applied.
7. Type update_show again. Press Enter to list Communication Manager files to verify the
new software update file was activated.
Stopping Communication Manager on the first S8720 Media
Server
To stop Communication Manager:
Type stop -acf. Press Enter to stop Communication Manager.
●
Configuring to allow restoring configuration data and translations
from the ftp server on the network
!
Important:
If you backed up files to the services laptop or the USB-connected Compact
Important:
Flash, do not perform this procedure. Go to
configuration data and translations from flash card or Services laptop
page 992.
If you backed up to the network of the customer, you must readminister the Ethernet port
connecting to the network. You must have the host name, IP address, subnet mask and default
gateway for the two media servers and the active server and the IP address for the Ethernet
port connecting to the customer network.
To configure the network parameters:
1. Under Server Configuration, click Configure Server to open the first page of the Configure
Server process.
The system displays the Select Server type window.
2. Select the appropriate server type (IP-PNC or fiber-PNC). Click Continue.
If you are unsure of the server type, see
3. Click Continue through the Review Notices to get to the Specify how you want to use
this wizard page.
4. Select Configure individual services. Click Continue.
Configuring to allow restoring
Recording the server connection type
On first S8720 Media Server
on
on page 957.
Issue 2.1 June 2006 991