Avaya S8100 Series Manual page 747

Premigration setup
The premigration team must complete the following tasks. If these tasks are not completed, do
not continue with the migration.
Some tasks need to be completed on site up to two weeks before starting the actual migration.
Freeze the translations.
●
Send the translations to STS.
●
Get the translations back from STS by e-mail.
●
For more information, see
When migrated from a DEFINITY system, you must complete the following additional tasks
before you start the migration:
Task
Determine which adapters
and cables you can reuse.
CAUTION:
If you are going to use the MOST Tool, you must complete the following eight tasks
before you freeze translations or save translations to an MO disk that is used to read
translations directly into an S8710 or S8720 Media Server.
If you want to use STS for translation conversion, go to
maintenance circuit packs.
CAUTION:
Be sure to perform this step
before freezing translations.
Verify that existing logins do
not start with a number or
an asterisk (*).
Migration paths on page 742.
Description
You cannot reuse the following items:
The 982LS Current Limiter (CURL) for an SI.
●
You must replace with larger CFY1B CURL.
The C-LAN 259A adapter. You must use
●
adapter for IP Media Processor for 100-Mbps
speed.
The CAT3 cable that is used with C-LAN. You
●
must use a CAT5 or better cable for 100-Mbps
speed.
on page 750.
Linux does not support logins that start with a number
or an asterisk (*). Use the SAT command list
logins to verify existing logins do not start with a
number or an asterisk (*).
Prerequisites
Replace any TN775/B/C
Issue 2.1 June 2006
1 of 4
747