Avaya S8100 Series Manual page 1129

4. Perform one of the following actions, depending on whether you want to use DHCP
addressing or static addressing. Use DHCP addressing usually with dedicated control
networks. Use static addressing usually with nondedicated control networks.
For DHCP addressing:
●
Note:
After you reseat the circuit pack, you must start the configuration operation within
Note:
5 seconds.
a. Reseat the IPSI circuit pack to enable the recessed configuration button on the IPSI
faceplate.
b. To set the Switch ID and cabinet number, press the recessed button on the IPSI
faceplate. When finished, continue with the next task,
and diffserv parameters
Note:
For more information about these settings, see Adding New Hardware — Avaya
Note:
S8500 and S8700 Series Media Servers (555-245-212).
For static addressing:
●
a. Connect the services laptop to the Services port on the IPSI faceplate.
b. Type telnet 192.11.13.6 to access the IPSI.
c. At the IPSI prompt, enter ipsilogin to log in to the IPSI IP Administration Utility.
d. Log in as craft and use the IPSI password
e. Type set control interface ipaddr netmask to enter the static IP address
and the netmask.
f. Enter quit to save the changes and end the IPSI session.
g. Type 192.11.13.6 to access the IPSI, and log in again.
h. Enter show control interface.
The system displays the IP address, the subnet mask, and the default gateway
information.
Verify that the proper information was entered.
i. If a default gateway is used, type set control gateway gatewayaddr where
gatewayaddr is the customer-provided IP address for the network gateway.
j. Enter quit to save the changes and end the IPSI session.
k. Type 192.11.13.6 to access the IPSI, and log in again.
l. Enter show control interface to verify the administration.
m. Enter quit to end the IPSI session.
on page 1130.
Conversion Tasks
Setting the VLAN parameters
Issue 2.1 June 2006 1129