Avaya S8100 Series Manual page 340

Migrating from a DEFINITY Server CSI in a CMC with a Linear Flash to an S8400 Media Server that uses a
Connecting cables
To connect cables:
1. On the rear of the carrier, connect the media server cable adapter into port 1 on the rear of
the TN8400AP Media Server circuit pack.
2. Connect the amphenol connector into slot A02 on the rear of the TN8412AP SIPI circuit
pack.
3. Connect the customer LAN cable into the port labeled ETH-B on the adapter in slot A01.
4. Connect the IPSI cable into the port labeled ETH-A on the adapter in slot A01.
5. Connect the other end of the IPSI cable to the amphenol connector in slot A02.
6. Connect the power plug on the DVD drive to a wall outlet.
7. Connect the USB DVD drive to the USB port on the faceplate of the TN8400AP Media
Server circuit pack.
8. On the DVD drive, ensure that the on/off/ext switch is in the EXT position.
9. Insert the Communication Manager CD into the USB DVD drive.
10. Connect the Services laptop to the Services port on the front of the TN8400AP Media
Server circuit pack.
11. Turn on the power to all cabinets.
Replacing the TN799C C-LAN circuit pack
If you need to replace the TN799C C-LAN circuit pack:
1. Remove the TN799C Control-LAN (C-LAN) circuit pack.
2. Place the circuit pack in an antistatic carrier or bag. You might need to reinstall this circuit
pack if you must stop the migration.
3. Insert the new TN799DP C-LAN circuit pack into the same slot.
4. Replace the 259A adapter and CAT3 cable on the connector panel.
5. Use the Amphenol adapter that you used for the TN799 circuit pack and a CAT5 cable.
340 Upgrading, Migrating, and Converting Media Servers and Gateways