Avaya S8100 Series Manual page 1054

Converting some or all direct-connect port networks to IP-connect
If you are converting the PN that contains the synchronization source, complete the following
procedure to remove or change the synchronization source.
1. At the SAT, enter change synchronization css.
2. Perform one of the following actions to remove or change the synchronization source:
If you are converting all PNs to IP-connect, type blanks in the Primary and Secondary
●
fields.
If you are converting only one of the direct connect PNs to IP-PNC, and if two PNs
●
remain fiber-connected, enter new circuit pack locations in the Primary and, optionally,
the Secondary fields.
Obtain these locations from the list of "Circuit Packs Available for Synchronization" below
the Primary and Secondary fields. If you enter both primary and secondary
synchronization sources, both locations must be from the same PN. Ensure that you
select working sync sources from a PN that is not being converted to IP-PNC.
3. Click Submit.
4. Verify that the synchronization sources are updated correctly:
5. Perform one of the following actions:
If you are converting all PNs to IP-PNC and have blanked out the Primary and
●
Secondary fields, enter list synchronization. Verify that the Primary and
Secondary fields for CSS are blank. Then continue with
page 1055.
If some PNs remain fiber-connected, complete the following steps:
●
a. Enter list synchronization.
1054 Upgrading, Migrating, and Converting Media Servers and Gateways
Adding new circuit packs on