Avaya S8100 Series Manual page 775

Adding IPSI information
To add IPSI information:
1. Type add ipserver-interface PNnumber, where PNnumber is the port network
number. Press Enter.
2. When you use a DHCP server, verify that the fields associated with the Primary IPSI and
Secondary IPSI (if equipped) are populated with default data. The Host and DHCP ID
fields are set by the DHCP server.
3. Verify the correct setting for the IP Control? field
If there is only one IPSI, set the IP Control? field to y.
●
If IPSIs are in fiber-connected PNs (CSS or ATM), set the IP Control? field to y.
●
If IPSIs are in fiber-connected PNs (direct-connect), set the IP Control? field to y if there
●
is more than 1 IPSI. Set the IP Control? field to n for the second IPSI.
If an IPSI is in a DS1-C-remoted PN, set the IP Control? field to n for the first IPSI to
●
maintain the 5:1 ratio of IPSIs to PNs. If the field is set to y, the system decreases the
ratio to 2:1.
4. If this system is high-reliability or critical-reliability, set the Administer secondary ip server
interface board field to y.
5. Verify that all the other fields are populated.
6. Press Enter to put the changes into effect.
7. Repeat Steps 1 through 5 for each port network.
Setting the alarm activation level
To set the alarm activation level:
1. Type change system-parameters maintenance. Press Enter.
2. In the CPE Alarm Activation Level field, select warning, minor, or major, depending on
the level that the customer wants. The default is none.
Migrating translations
Issue 2.1 June 2006 775