Avaya S8100 Series Manual page 477

Media servers and gateways
Hide thumbs Also See for S8100 Series:
Table of Contents

Advertisement

Migrating a DEFINITY Server SI Direct-Connect in an
SCC to a Direct-Connect
Note:
Once you complete the migration to fiber-PNC, you can convert to IP-PNC. See
Note:
Converting PNs to IP-PNC
Use these procedures to migrate from an existing DEFINITY Server SI direct-connect in an
single carrier cabinet (SCC) system to the Avaya S8500 or S8700-Series Media Server with a
direct-connect configuration.
These procedures are for migrating direct-connect to direct-connect configurations. If you want
to change one or more port networks (PNs) to a fiber-port network connectivity (PNC)
configuration, see
The existing system uses expansion interface (EI) circuit packs to provide port network
connectivity (PNC) for one, two, or three PNs. The existing system must be standard reliability.
In all instances you can reuse the cabinets as PNs. However, you can add an EI-connected
G650 Media Gateway PN if the existing system has only one or two PNs.
To migrate an existing DEFINITY Server SI in an SCC, you use one TN2312BP IPSI circuit pack
to control from one to three PNs. Avaya recommends that you install the IPSI in the cabinet in
the A position in the existing processor port network (PPN) instead of in one of the expansion
port networks (EPNs). But before you install the IPSI, you must change the PPN to a PN:
Replace the processor control cabinet with an expansion control cabinet
Remove all the control circuit packs
This migration affects service.
Basic migration steps
To migrate from DEFINITY platforms, you must:
Install the media server. If Avaya supplies the Ethernet switch(es), and uninterruptible
power supplies (UPSs), you also must install the switch and the UPS in the 19-inch rack.
For more information, see Quick Start for Hardware Installation: Avaya S8500 Media
Servers (555-245-701) or Quick Start for Hardware Installation: Avaya S8700-Series
Media Server (555-245-703).
Change the existing processor control cabinet/carrier to an expansion control cabinet/
carrier
Replace tone clock circuit pack with IPSI circuit packs
on page 1041.
Conversions
on page 1035.
Basic migration steps
Issue 2.1 June 2006
477

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents