Avaya S8100 Series Manual page 852

Migrating an Avaya IP600/S8100 to an S8700-Series Media Server with IP-PNC
Adding IPSI translations to Communication Manager
To add IPSI translations to Communication Manager:
1. Type change system-parameters ipserver-interface. Press Enter.
2. Verify that the Primary Control Subnet Address and Secondary Control Subnet
Address (was equipped) fields are correct.
The subnet work addresses must match the most significant three octets (the first three
groups of digits in the subnet work address) of the Server IP address that appears on the
control network entry from the completed Electronic Preinstallation Worksheet (EPW).
An asterisk (*) to the right of the Subnet Address field means that although a subnet work
address appears, this address is incorrect. Avaya Communication Manager call processing
software does not have the subnet information. After you verify the information on the
screen, submit this form with or without changes to update Communication Manager with
the correct subnet work information.
!
CAUTION:
If the information in either the Primary Control Subnet Address fields, the
CAUTION:
Secondary Control Subnet Address field, or both, is incorrect, you must
change the information on the media servers. Use the Maintenance Web
Interface. Under Server Configuration and Upgrades, click Configure Server to
change the media server configuration. Then return here to perform Step 3.
3. Verify that the Switch Identifier field is set correctly for this installation. The correct Switch
Identifier must be entered here before you administer the TN2312 IPSI circuit packs.
4. Verify that the IPSI Control of Port Networks field is set to disabled.
5. Press Enter to submit the screen.
Note:
The information that you provide depends on whether the IPSIs get static
Note:
addresses or the addresses are assigned automatically through DHCP.
Adding IPSI information
To add IPSI information:
1. Type add ipserver-interface PNnumber where PNnumber is the port network
number. Press Enter.
2. When you use static addressing, in the Host field, type in the IP address for the IPSI in the
port network that is listed in the Location field.
3. Verify that all the other fields are populated.
852 Upgrading, Migrating, and Converting Media Servers and Gateways