Avaya S8100 Series Manual page 1189

Installing the duplicated IPSI circuit pack
Install the IPSI in the appropriate slot number identified in the Secondary column on the right of
ISPI Slot Locations table.
Note:
For this task with SCC1 Media Gateways, you need a long ribbon cable and the
Note:
Cable PassThrough Kit (comcode 700219413). For this task with MCC1 Media
Gateways, you need a short ribbon cable (comcode 700168727).
To install the duplicated TN2312BP IPSI circuit pack, perform the following steps, depending on
which type of media gateway you are working with:
For the G650 Media Gateway:
●
For the MCC1 Media Gateway:
●
For the SCC1 Media Gateway:
●
Note:
You can insert the IPSI circuit pack and administer it ahead of time. The circuit
Note:
pack is hot-swappable. Therefore, you do not need to turn off the PNs or the
carriers.
For the G650 Media Gateway:
1. Insert the TN2312BP Internet Protocol Server Interface (IPSI) circuit packs into the B01 slot
in media gateway B.
For the MCC1 Media Gateway:
1. Insert the TN2312BP IPSI circuit pack part way into the TONE-CLOCK slot on the standby
carrier (B).
2. Attach one end of the long ribbon cable to the connector on the component side of the
circuit pack. The red line must be on the bottom (pin 1).
3. Push the tabs on the ends of the connector inward to lock the connector in place. See
Figure 93: Ribbon Cable Connector
on page 1189
on page 1189
on page 1191
on page 1190.
Procedure
Issue 2.1 June 2006 1189