Avaya S8100 Series Manual page 635

Connecting to the active media server
To connect to the active media server:
1. Start a Web browser.
2. Log in as craft or dadmin.
3. Click Launch Maintenance Web Interface.
4. Under Server, click Status Summary to verify that the standby media server was refreshed.
Do not continue until the standby media server is refreshed.
5. Start a SAT session with Native Configuration Manager or Avaya Site Administration.
6. Login as craft or dadmin.
Installing the translations
To install the translations:
1. Type reset system 4. Press Enter.
2. Return the STS-supplied PCMCIA flash card to Avaya.
To add the IPSI translations before you save translations, continue with
translations on page 637.
Adding IPSI translations to Communication Manager
To add IPSI translations to Communication Manager:
1. Type change system-parameters ipserver-interface. Press Enter.
2. Verify that the Primary Control Subnet Address and Secondary Control Subnet
Address (was equipped) fields are correct.
The subnet work addresses must match the most significant three octets (the first three
groups of digits in the subnet work address) of the Server IP address that appears on the
control network entry from the completed Electronic Preinstallation Worksheet (EPW).
An asterisk (*) to the right of the Subnet Address field means that although a subnet work
address appears, this address is incorrect. Avaya Communication Manager call processing
software does not have the subnet information. After you verify the information on the
screen, submit this form with or without changes to update Communication Manager with
the correct subnet work information.
Migrating translations
Backing up
Issue 2.1 June 2006 635