Avaya S8100 Series Manual page 1021

5. Click Continue.
Note:
The following step applies only if you are using software duplication.
Note:
6. On the Configure Interface page, set the speed for Ethernet 0: Server Duplication Link to
either:
AUTO SENSE
●
1 Gigabit full duplex
●
7. Click Continue through all the screens, checking for new screens and new fields on
existing screens as mentioned in the Software Release Letter.
Note:
You must click through all the screens whether there are changes or not.
Note:
8. On the Configure ESS window:
If the server is a primary control main, click This is NOT an enterprise survivable
●
server
If the server is an ESS server, click This is an enterprise survivable server (ESS)
●
9. Click Continue.
10. When you complete all the new fields, as necessary, click Continue on the Update System
screen. The Update System screen shows each configuration task as the task completes.
When done, the screen shows the line All configuration information was entered.
11. Click Close Window to close the Configure Server wizard.
12. Disconnect from the media server.
Rebooting the second S8720 Media Server
Reboot is necessary to initialize server settings that are restored but not yet activated.
To reboot the second S8720 Media Server:
1. On the Maintenance Web Interface, under Server, click Shutdown Server.
The system displays the Shutdown Server window.
2. Make the following selections:
Select Immediate Shutdown
●
Select Restart Server after Shutdown
●
3. Click Shutdown.
On the second S8720 Media Server
Issue 2.1 June 2006 1021