Avaya S8100 Series Manual page 1213

Checklist for converting a port network to duplicated TN2602AP IP Media Resource 320 circuit packs
Upgrading firmware on the new TN2602AP circuit packs, if
necessary
If you determined that you must upgrade the firmware on newly-installed TN2602AP circuit
packs, if any, do so now. See Upgrading, Migrating, and Converting Media Servers and
Gateways (03-300412), "Chapter 4: Upgrading Firmware on TN Circuit Packs and Media
Modules."
Administering the node name for the TN2602AP circuit pack, if
necessary
Note:
If you are replacing one or two TN2302 circuit packs, you can reuse the node
Note:
name and IP address for those circuit packs. Therefore, you may be able to skip
this task for one or both TN2602AP circuit packs.
To administer the node names for the circuit packs, perform the following steps:
1. Type change node-names ip and press Enter.
2. Type in the node names and IP addresses for the TN2602AP.
change node-names ip
Name
cognac
default
medres03a01
medpro02b04
medpro02b05
clan03a04
clan03a05
clan04b04
( 12 of 12
Use 'list node-names' command to see all the administered node-names
3. Type display circuit-packs and press Enter. Verify that the TN2602AP shows up in
the Code column.
4. Repeat steps 1 through 3 for the second circuit pack, if necessary.
IP Address
172.16 .19 .2
0 .0 .0 .0
192.168.1 .82
192.168.1 .83
172.16 .19 .222
192.168.1 .80
172.16 .19 .220
172.16 .19 .118
. . .
. . .
. . .
. . .
administered node-names were displayed )
IP NODE NAMES
Name
Page 1 of
IP Address
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
Issue 2.1 June 2006
1
1213