Avaya S8100 Series Manual page 333

Resetting the SIPI
●
Enabling control of the SIPI
●
Verifying SIPI translations
●
Verifying SIPI connectivity
●
Verifying the customer data
●
Verifying circuit pack locations
●
Verifying circuit pack insertion
●
Verifying the IP addresses
●
Checking the link status
●
Upgrading firmware
●
Testing the installation
●
Busying out previously busied out trunks
●
Troubleshooting the migration
●
Returning replaced equipment
●
Premigration administration
This migration is a service-affecting event. The CMCs must be turned off to replace the
processor and tone clock circuit packs. Before you turn off the cabinets, you must perform the
following premigration administration.
Accessing Remote Feature Activation
Use this section for information on how to access Remote Feature Activation (RFA).
You can access the RFA information page for these items (if not already installed on your PC):
Note:
For Release 10 and later, do not use the FET because the license contains the
Note:
existing switch configuration information. For Releases G3v4 and earlier, do not
use the FET because the ASD tool and process captures the existing switch
configuration information.
on page 349
on page 350
on page 350
on page 351
on page 351
on page 351
on page 352
on page 352
on page 352
on page 353
on page 353
on page 354
on page 354
on page 353
Premigration administration
Issue 2.1 June 2006 333