Avaya S8100 Series Manual page 1127

Installing the CLAN circuit packs
Add the CLAN circuit packs to the slots that you designated for CLANs.
To install a CLAN circuit pack:
1. Insert the TN799DP circuit pack into the slot that you previously prepared for the CLAN.
2. Push firmly on the faceplate until the circuit pack is seated, then close the latch.
3. On the SAT, open the Circuit Packs screen using
display circuit-pack cabinetnumber and verify that the TN799DP circuit packs
are shown in the appropriate slots.
Adding cables for the new circuit packs
IPSI circuit packs are connected to an Ethernet switch in the control network. Media processor
and CLAN circuit packs are connected to the customer LAN.
!
Important:
Each of the three types of circuit packs requires an I/O adapter that is connected
Important:
to the backplane amphenol connector. The adapters for the three types of circuit
packs are different and not necessarily interchangeable. Also, the adapters for
the TN2302AP and TN2602AP media processor circuit packs are different.
Ensure that you use the correct adapter that corresponds to each type of circuit
pack.
Connecting IPSI cables
To connect an IPSI slot to the control network:
1. Connect the TN2312BP I/O adapter to the backplane amphenol connector that corresponds
to the slot in which the TN2312BP is installed.
2. Connect a CAT5 or better Ethernet cable to the RJ45 connector on the IPSI adapter.
3. Connect the other end of the CAT5 cable to the Ethernet switch.
4. For the G650 gateway only, if the maintenance function is used, connect one end of the
serial maintenance cable to the DB9 connector on the IPSI adapter. Connect the other end
to the Emergency Transfer panel to provide 1 alarm output and 2 alarm inputs.
Connecting the media processor cables
!
Important:
If you are replacing a TN2302 with a TN2602, ensure that you replace the
Important:
TN2302 I/O adapter with a TN2602 adapter.
To connect a media processor slot to the LAN:
1. Connect the medial processor I/O adapter to the backplane amphenol connector that
corresponds to the slot in which the media processor circuit pack is installed.
Conversion Tasks
Issue 2.1 June 2006 1127