Avaya S8100 Series Manual page 1132

Converting some or all ATM port networks to IP-PNC
5. Verify the number of TN2602 circuit packs with 80 VoIP channels and the number of
TN2602 circuit packs with 320 VoIP channels.
6. To open the IP Node Names screen, enter change node-names ip and then enter the
node names and the IP addresses for the TN2602APs.
7. For each new TN2602AP circuit pack, enter add ip-interface UUCSS to open the IP
Interfaces screen.
Complete each field with the information for this TN2602AP.
Note:
If you do not have a gateway IP address, leave the Gateway Address field
Note:
blank.
8. To test connectivity to the IP endpoints through each TN2602AP, enter ping ip-address
ipadress board UUCSS, where ipaddress is the IP address of an IP endpoint that is
on the same subnetwork as the TN2602AP. UUCSS is the cabinet, carrier, and slot location
of the TN2602AP.
9. Repeat step
10. Make an external trunk call to a telephone on the port network and leave the call active.
11. To verify call processing, enter status media-processor board UUCSS.
The Media Processor Status screen appears.
12. Look at the LINKS and DSP CHANNEL STATUS categories to determine whether the call is
being processed.
Administering the CLAN circuit pack
To administer the TN799DP circuit pack:
1. From the active media server, log on to a SAT session.
2. To verify that the TN799DP is correctly registered in the installed location, enter list
configuration board UUCSS.
3. Check the firmware version in the Vintage column. If the version is earlier than the latest
version that is available on the Avaya Support web site, you must upgrade the TN799DP
firmware.
4. To open the IP Node Names screen, enter change node-names ip and then enter the
node names and the IP addresses for the TN799DPs.
5. For each new TN799DP circuit pack, enter add ip-interface UUCSS to open the IP
Interfaces screen.
Complete each field with the information for this TN799DP.
Note:
If you do not have a gateway IP address, leave the Gateway Address field
Note:
blank.
1132 Upgrading, Migrating, and Converting Media Servers and Gateways
7 for another IP endpoint on a different subnet.