Conversion Tasks
Before you start the conversion tasks, you must ensure that the S8700-series Media Servers
are running Communication Manager release 3.1 or later.
You must complete the following tasks to convert from an ATM configuration to an IP-PNC
configuration.
!
Important:
For more information on how to install the IPSI, the media processor, and the
Important:
CLAN circuit packs, see Adding New Hardware — Avaya S8500 and S8700
Series Media Servers (555-245-212).
Conversion tasks checklist
The following checklist identifies the major task in the conversion procedure:
Changing ATM synchronization
●
Adding new circuit packs
●
Upgrading firmware on new circuit packs.
●
Disabling PNC duplication.
●
Removing fiber administration.
●
Enabling PNC duplication.
●
Removing fiber-related hardware.
●
Administering PN synchronization.
●
Completing Post-conversion tasks
●
Changing ATM synchronization, if necessary
If you are not converting the PN that contains the ATM synchronization source, do not perform
this procedure. Continue to
!
Important:
Synchronization for the ATM is derived from a connection through an
Important:
ATM-connected PN. If you are not converting all ATM port networks to IP-PNC,
Avaya recommends that you do not convert the PN that contains the ATM
synchronization source. If you are converting the PN that contains the ATM
synchronization source, convert this PN last.
Adding new circuit packs
on page 1123.
Issue 2.1 June 2006
Conversion Tasks
1121