Avaya S8100 Series Manual page 376

Migrating from a DEFINITY Server CSI in a CMC with an ATA Flash to an S8400 Media Server
3. Type arp -d 192.11.13.6. Press Enter. This command produces one of the following
responses:
The command line prompt displays when the cache is cleared.
●
The message The specified entry was not found appears when the specified IP
●
address does not currently appear in the ARP cache.
4. To access the media server, type ping -t 192.11.13.6. Press Enter.
The -t causes the ping to repeat until you get a response. When you get a response, in
about 3 minutes, wait an additional 30 seconds before you go back to the Web interface.
5. To stop the ping, type ctrl c. Press Enter.
6. Close the MS-DOS window.
Logging in to the SIPI
To log in to the SIPI:
1. Type telnet 192.11.13.6. Press Enter to open the Telnet window and connect to the
SIPI
Prompt = [IPSI]:
Note:
While connected to the SIPI, type help or ? to obtain online help. Most
Note:
commands have two or three letter abbreviations.
2. Type ipsilogin. Press Enter. The abbreviated command is il.
Note:
The craft login used on the SIPI has a different password than the craft login used
Note:
on the media servers.
3. Log in as craft.
Prompt = [IPADMIN]:
Setting the control interface
To set the control interface:
1. Type show control interface. Press Enter.
2. Type show port 1. Press Enter to see the current settings.
376 Upgrading, Migrating, and Converting Media Servers and Gateways