Avaya S8100 Series Manual page 370

Migrating from a DEFINITY Server CSI in a CMC with an ATA Flash to an S8400 Media Server
Inserting circuit packs
To install circuit packs into the CMC:
1. Install the TN8412AP S8400 IP Interface (SIPI) circuit pack into slot A02.
2. Install the TN8400AP Media Server circuit pack into slot A01.
3. If the system had a TN767, TN2207, or TN2313 DS1 Interface circuit pack, install the
TN464HP DSD1 Interface circuit pack in any open slot.
Connecting cables
To connect cables:
1. On the rear of the carrier, connect the media server cable adapter into port 1 on the rear of
the TN8400AP Media Server circuit pack.
2. Connect the amphenol connector into slot A02 on the rear of the TN8412AP SIPI circuit
pack.
3. Connect the customer LAN cable into the port labeled ETH-B on the adapter in slot A01.
4. Connect the IPSI cable into the port labeled ETH-A on the adapter in slot A01.
5. Connect the other end of the IPSI cable to the amphenol connector in slot A02.
6. Connect the power plug on the DVD drive to a wall outlet.
7. Connect the USB DVD drive to the USB port on the faceplate of the TN8400AP Media
Server circuit pack.
8. On the DVD drive, ensure that the on/off/ext switch is in the EXT position.
9. Insert the Communication Manager CD into the USB DVD drive.
10. Connect the Services laptop to the Services port on the front of the TN8400AP Media
Server circuit pack.
11. Turn on the power to all cabinets.
370 Upgrading, Migrating, and Converting Media Servers and Gateways