Avaya S8100 Series Manual page 1133

6. To display the Data Module screen, enter add data-module next.
Enter ethernet in the Type field and complete the rest of the fields on the screen.
7. To test connectivity to the IP endpoints through each TN799DP, enter ping ip-address
ipadress board UUCSS, where ipaddress is the IP address of an IP endpoint that is
on the same subnetwork as the TN799DP. UUCSS is the cabinet, carrier, and slot location of
the TN799DP.
8. Repeat step
Upgrading firmware on the new circuit packs
The IPSI, the media processor, and the CLAN circuit packs that you added must have the latest
available firmware installed. Check the firmware version that is installed on each circuit pack
and compare with the latest version that is available on the Avaya Support Web site. If the
circuit pack does not have the latest version installed, you must upgrade the firmware on that
circuit pack. As part of the presite tasks, you copied the latest firmware to your laptop. If you did
not copy the firmware, you must download the latest firmware files from the Avaya Support Web
site at http://support.avaya.com.
Upgrading IPSI firmware, if necessary
For more information about how to upgrade the IPSI firmware, see
IPSIs and SIPIs
Upgrading media processor and CLAN firmware, if necessary
For more information about how to upgrade firmware on the TN2602AP or the TN799DP circuit
packs, follow the instructions in
page 293.
Disabling PNC duplication, if necessary
If the bearer network is duplicated, you must remove the duplication before you remove the
fiber-optic connections. If the system does not have PNC duplication, continue with
fiber-related administration
To remove PNC duplication, open a SAT session and complete these steps:
1. Enter status pnc to check which of the duplicated PNCs is active.
2. If the B-PNC is active, enter reset pnc interchange to make the A-PNC active.
3. Enter busyout pnc-standby to busyout the standby PNC.
8 for another IP endpoint on a different subnet.
on page 283.
Upgrading firmware on programmable TN circuit packs
on page 1134.
Conversion Tasks
Upgrading firmware on the
on
Removing
Issue 2.1 June 2006 1133