Avaya S8100 Series Manual page 1234

Converting software duplication link to a DAL1 link on an S8720 Media Server
Reconfiguring the Ethernet interface
To reconfigure the Ethernet interface so that the duplication link uses the DAL1 board, perform
the following steps:
1. Under Server Configuration, click Configure Server to open the first page of the Configure
Server process.
2. Click Continue through the Review Notices to get to the Specify how you want to use
this wizard page.
3. Select Configure individual services and click Continue.
4. Click Set Identities from the main menu.
5. On the Set Server Identities window:
Select This is a duplicated server using duplication hardware.
●
Under Select NIC Usage, assign the Ethernet ports according to the following table, and
●
click Continue.
1234 Upgrading, Migrating, and Converting Media Servers and Gateways
Control Hardware Memory Duplication
Network
Dedicated
●
●
●
Nondedicated
●
LAN to Eth4
which is the 3rd port from the
left on the quad NIC
CNA to Eth0
which is the port labeled "1" on
the server
CNB (if used) to Eth3
which is the 2nd port from the
left on the quad NIC
LAN or CNA to Eth0
which is the port labeled "1" on
the server
CNB (if used) to Eth3
which is the 2nd port from the
left on the quad NIC