Avaya S8100 Series Manual page 1003

3. Type list survivable. Press Enter.
4. Type status ess clusters. Press Enter.
If ESS clusters are not registered, follow the normal escalation procedures.
5. Type status ess port-networks. Press Enter.
If any port networks controlled by an ESS are down, type get forced-takeover
ipserver-interfac all. Press Enter.
6. Repeat step 6.
If the port networks are still down, follow the normal escalation procedures.
Removing the remaining S8700 or S8710 Media Server
This section describes the procedures you must perform to remove the remaining S8700 or
S8710 Media Server.
Removing the S8700 or S8710 Media Server from the rack
To remove the S8700 or S8710 Media Server from the rack:
1. Label and disconnect cables.
2. Disconnect the Services laptop.
3. Remove the S8700 or S8710 Media Server from the rack.
Removing the DAL1 card, if necessary
Perform this procedure only if:
Migrating from an S8710, and
●
S8720 uses hardware-assist memory duplication, and
●
Reusing the DAL1 from the S8710
●
To remove the DAL1 card:
1. Turn off the media server.
2. Extend the media server from the rack.
3. Lift up on the hood latch handle and remove the access panel.
Removing the remaining S8700 or S8710 Media Server
Issue 2.1 June 2006 1003