Avaya S8100 Series Manual page 1099

4. Enter change system-parameters duplication to open the duplication screen.
5. In the Enable Operation of PNC Duplication? field, enter n and press Submit.
Removing fiber-related administration
Before you can use the IP connections, you must remove the fiber administration for each PN
that you are converting to IP-PNC.
Complete the following steps at the SAT to busyout and remove the fiber links for each PN that
you are converting to IP-PNC:
Tip:
To view the fiber link numbers and the endpoints, enter list fiber-link.
Tip:
1. Enter busyout fiber-link n, where n is the link number for the fiber connection.
2. Enter remove fiber-link n.
3. Repeat steps
Enabling PNC duplication, if necessary
If the final configuration is a mixture of fiber-PNC and IP-PNC PNs and if the fiber- connect
portion is duplicated, you must enable PNC duplication.
To enable PNC duplication at the SAT:
1. Enter change system duplication to open the PNC Duplication screen.
2. Enter y in the Enable Operation of PNC Duplication? field and press Submit.
Removing fiber-related hardware
Complete these steps for each PN that you are converting to IP-PNC:
1. Remove the fiber cables that connect the EI circuit packs in the PNs.
2. Remove the TN570 expansion interface (EI) circuit packs from the port network carriers or
gateways.
3. At the SAT, enter change circuit-pack.
a. Enter blanks in the TN570 EI fields that correspond to the PNs that you converted to
IP-PNC.
b. Press Submit.
1 and 2 for each IP-PNC PN.
Conversion Tasks
Issue 2.1 June 2006 1099