Avaya S8100 Series Manual page 1160

Converting S8300 ICC mode to LSP mode
3. Reassign endpoints from
the ICC to this primary
controller.
For information on
updating translations, see
the Administrator Guide
for Avaya Communication
Manager, 03-300509.
4. Update the alternate
controller list on the
DHCP server.
See "Considerations for
IP Phones Supported by a
Local Survivable
Processor" in Chapter 9.
5. Telnet to the MGP and
change gateway's
controller list.
See "Setting up the
controller list for the
G700" in Chapter 9.
1160 Upgrading, Migrating, and Converting Media Servers and Gateways
Task Steps/Comments
Update translations — add stations and trunks.
●
- If the primary controller is a new installation, using
the Avaya Installation Wizard and the Electronic
Pre-Installation Worksheet (EPW) is
recommended
- Alternatively, use SAT commands.
Place test calls to verify.
●
Reassign IA770 users to the messaging system
●
used by this primary controller. Enter test
messages to verify.
On the DHCP server
On the gateway's MGP
Clear the gateway's controller list.
●
Enter the IP addresses of the primary controller
●
and up to three alternate controllers.
Set the LSP transition points.
●
If the media gateway is a G350, enter:
●
copy running-config startup-config
Reset MGP
●
2 of 5