Avaya S8100 Series Manual page 350

Migrating from a DEFINITY Server CSI in a CMC with a Linear Flash to an S8400 Media Server that uses a
Enabling control of the SIPI
To enable control of the SIPI:
Note:
Ensure that the TN8412P SIPI has the current firmware.
Note:
!
CAUTION:
This procedure allows the media server to take control of the SIPI-controlled port
CAUTION:
network(s). Failure to complete the procedure correctly can result in no
connection to the network.
1. Type add cabinet 1. Press Enter.
2. Administer the appropriate cabinet type and carriers.
3. Type add ipserver-interface 1 where 1 means port network. Press Enter.
4. In the Host field, type in the IP address that was programmed into the SIPI. Press Enter.
5. Type save translation. Press Enter.
6. Type change system ipserver-interface. Press Enter.
7. In the IPSI Control of Port Networks field, type enabled. Press Enter.
8. Type save translation. Press Enter.
9. Verify the translation migration was successful.
Place test calls, verify trunk status (if applicable), and so forth.
The media server now controls all the port networks.
Verifying SIPI translations
To verify SIPI translations:
1. Type list ipserver-interface. Press Enter.
2. Verify that the SIPI circuit pack(s) is translated.
350 Upgrading, Migrating, and Converting Media Servers and Gateways