Avaya S8100 Series Manual page 604

Migrating an Avaya IP600/S8100 to an S8500 Media Server
Setting the VLAN and diffserv parameters
To set the VLAN parameters and the diffserver parameters:
1. Log back in as craft.
2. To display the quality of service values, type show qos. Press Enter.
3. If necessary, use the following commands to set the VLAN and diffserv parameters to the
recommended values shown.
Note:
Use Help to obtain syntax guidelines for these commands.
Note:
Type set vlan priority 6
●
Type set diffserv 46
●
Type set vlan tag on
●
Type set port negotiation 1 disable
●
Type set port duplex 1 full
●
Type set port speed 1 100
●
4. To check the administered values, type show qos. Press Enter.
5. To exit, type quit. Press Enter.
!
Important:
Ensure that the port settings on the Ethernet switches are set to the same values
Important:
as shown in the set port commands in step 3.
Resetting the IPSI
To reset the IPSI:
1. Type reset. Press Enter
Answer Y to the warning.
Note:
Resetting the IPSI terminates the administration session. If further administration
Note:
is required, start a new SSH session to the IPSI.
Note:
The IP address, subnet mask, and gateway control network settings become
Note:
effective when you exit the IPADMIN session.
604 Upgrading, Migrating, and Converting Media Servers and Gateways